© 2013 American Honda Motor Co., Inc. – All Rights Reserved. BII 13404 (1301) 23 of 30
75. Route the antenna cable down the A-pillar as shown.
Secure the antenna cable to the vehicle harness with
five wire ties.
76. Using scissors, cut one urethane tape in half.
Starting near the wire tie, wrap three halves of
urethane tape around the antenna cable at the
measurements shown.
VEHICLE
HARNESS
5 WIRE
TIES
ANTENNA
CABLE
WIRE
TIE
ANTENNA
CABLE
VEHICLE
FRAME
SECTION
VIEW
VEHICLE
HARNESS
Be careful not
to secure the
wire ties over
the holes.
URETHANE
TAPE
(Cut in half.)
3 HALVES OF
URETHANE
TAPE
SECTION
VIEW
WIRE
TIE
ANTENNA
CABLE
35 mm
(1.4 in.)
20 mm
(0.8 in.)
20 mm
(0.8 in.)
URETHANE TAPE
(Remaining in step 46.)
ANTENNA
CABLE
77. Route the antenna cable down next to the instrument
panel, and tuck the antenna cable between the
driver’s A-pillar and the instrument panel.
78. Gently pull the excess antenna cable down and
route it as shown. Secure the engine starter harness
and the antenna cable to the vehicle harness with
one wire tie.
FRONT
INSTRUMENT
PANEL
DRIVER’S
A-PILLAR
ANTENNA CABLE
ANTENNA CABLE
WIRE TIE
HOOD
OPENER
ENGINE
STARTER
HARNESS
VEHICLE
HARNESS
Comments to this Manuals