Acura 2009 MDX User Manual download pdf (Page 63)

62 Navigation System

Driving to Your Destination

Map Orientation

The map can be orientated two ways:

• North-up: North pointing up as you

would normally view a paper map.

• Heading-up: The map constantly

rotates so the road you are driving on

always points up (as you see the road

through your front windshield).

NOTE:

The red arrow in both heading symbols

always shows the direction north.

Push in on the Interface Dial on the

map or guidance screen and select

North-up or Heading-up to switch

between the available orientation, or say

“Display heading up” or “Display north

up.”

In the larger map scales (above 1 mile or

1.6 kilometer), the map is always

oriented with north facing upward. You

cannot change the orientation.

To view other areas on the map, move

the Interface Dial left, right, up, or

down. The map will shift in that

direction. To return the map to your

current location, press either the MAP/

GUIDE, the CANCEL, or the NAVI

BACK button on the steering wheel.

The display automatically changes to

the map screen when you reach your

destination. Press the MENU button to

return to the Enter destination by

screen.

NOTE:

• For information on the available

voice commands, see Voice

Command Index on page 150.

• If you are en route and the Interface

Dial is moved, the “Time to

Destination” and “Distance to

Destination” indications are

replaced with an indicator showing

distance from the current vehicle

location.

Destination Icon

The destination icon only shows the

approximate location of the destination.

This occurs because a city block can

have as many as 100 possible addresses

(for example, the 1400 block is followed

by the 1500 block). Most cities use only

a portion of the 100 possible addresses

(for example, in the 1400 block, the

addresses may only go up to 1425

before the 1500 block starts). Therefore,

the address 1425 will be shown a

quarter of the way down the block by

the system instead of near the end of the

block where the destination is actually

located.

Tip:

When en route, you can view a map

showing your destination. Using voice

control, say “Display destination map.”

“North Up”

“Heading Up”

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 174 175

Comments to this Manuals

No comments