Acura 2011 TL User Manual download pdf (Page 73)

＊

＊

The left or right turn signal indicator

blinks when you signal a lane change

or turn. If an indicator does not blink

or blinks rapidly, it usually means

one of the turn signal bulbs is

burned out (see pages and ).

Replace the bulb as soon as possible,

since other drivers cannot see that

you are signaling.

When you press the hazard warning

button, both turn signal indicators

and all turn signals on the outside of

the vehicle flash.

This indicator normally comes on

when you turn the ignition switch to

the ON (II) position and goes off

after the engine starts. If it comes on

at any other time, there is a problem

in the electric power steering system.

Models equipped with the

keyless access system have an

engine start/stop button instead

of an ignition switch. ON Mode

is the equivalent of ON (II). For

more information, see pages

and .

If this happens, stop the vehicle in a

safe place and turn off the engine.

Reset the system by restarting the

engine. The indicator will stay on,

but should go off after driving a

short distance. If it does not go off,

or comes back on again while driving,

take the vehicle to your dealer to

have it checked. With the indicator

on, the EPS may be turned off,

making the vehicle harder to steer.

If you turn the steering wheel to the

full left or right position repeatedly

while stopping or driving at very low

speed, you may feel slightly harder

steering in order to prevent damage

to the steering system caused by

overheating. This may also happen if

you hold the steering wheel on the

full left or right position for a while.

You will also see a ‘‘CHECK POWER

STEERING SYSTEM’’ message on

the multi-information display.

:

181178

524 528

Instrument Panel Indicators

Turn Signal and

Hazard Warning

Indicators

Electric Power Steering

(EPS) Indicator

70

10/07/29 11:48:44 31TK4620_075

2011 TL

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 613 614

Comments to this Manuals

No comments